All right, today I’m going to show you how
to replace the iPhone 5c screen in three minutes. First of all, just take out the bottom screws.
These are the same size screws as all the other iPhones, so any of those Pentalobe screwdrivers
will work. There’s two screws right next to the charging ports. Take those out. The
second step is a little bit harder. You need a suction cup and a plastic pry tool, so lift
up with a suction cup and just kind of twist your pry tool in there to lift up the screen
out of the bottom latches. Once it’s lifted up gently pry the screen away from the body
and the other latches along the side of the screen will pull up as well. Be very careful
with the screen, especially if it’s broken or cracked. Next there’s four screws along
this plate. There are three different sizes so make sure when you take the screws out
you’re going to remember where they go when you have to reassemble the phone later. Once
this metal plate is off, there are four metal latches that you have to lift up. They’re
kind of like Legos. So just kind of pry up and unsnap them one by one. Technically you
don’t have to do the one on the bottom left, that’s the one that’s attached to the
battery. I got a little carried away and decided to do it anyway. Anyway, once the three important
ones are unlatched your screen is off. Now, depending on where you get your screen you
might have a few more steps. You might have to take the home button and replace it, and
replace this back panel as well. But all you have to have to do is loosen up those screws
and transfer it right over to the new screen. Once you’ve done that, you can take the
latches, the little ribbing cables, and snap them into place just like Legos. Be very very
gentle with these because if you rip them, you will have problems. One of them does go
over to the earpiece so you might need to swap that over as well just depending on where
you get your screen. Amazon usually has the cheapest screens so I will list them in the
video description below as soon as they become available. Take your four screws that you
kept organized earlier, and pop them into place. Screwing them in. This is just your
regular Phillips screwdriver. And then make sure the top is aligned and snap the screen
gently into place. There will be a series of satisfying clicks as you press the phone
back together again. And as you see the phone is completely back together, and it looks
exactly like new. There is no raise in the screen, it is all flush just like it was before.
Don’t forget to put your bottom two screws back in and you are set. If you have any questions,
make sure to leave them in the comments below. Don’t forget to like if this video helped
you and don’t forget to subscribe. Thanks for watching.